MORLEY ZX10Se Installation Manual download pdf (Page 9)

ZXr-A / ZXr-P Repeaters MORLEY-IAS

Operation & Installation Manual Document No. 996-144, Revision: 02, Page 9 of 16

3.4 Address Setting

• Set the repeater address in binary using the address switch on the repeater chassis assembly PCB. (See

Figure 9 above).

• The address can be set in the range 1 – 126.

• It is not necessary to set an address for the ZXr-P (passive) repeater. The address can be set to 0 (all

switch positions OFF). In this mode, the passive repeater will listen to the RS485 communications and will

update its Liquid Crystal Display and LED with the appropriate information. However, if the repeater

becomes disconnected from the RS485 link, the FACP will not report a fault condition.

• To report a fault condition at the FACP, in the event that a passive repeater becomes disconnected, set

the passive repeater to an address in the range 1 – 126.

• Refer to

Table 1 for address positions.

• When commissioned, use the panel ‘Auto-Learn’ function to learn / register the devices installed on the

peripheral loop.

ADDRESS

SWITCH POSITION

SW1:1 SW1:2 SW1:3 SW1:4 SW1:5 SW1:6 SW1:7 SW1:8

ON OFF OFF OFF OFF OFF OFF OFF

OFF ON OFF OFF OFF OFF OFF OFF

ON ON OFF OFF OFF OFF OFF OFF

OFF OFF ON OFF OFF OFF OFF OFF

ON OFF ON OFF OFF OFF OFF OFF

OFF ON ON OFF OFF OFF OFF OFF

ON ON ON OFF OFF OFF OFF OFF

OFF OFF OFF ON OFF OFF OFF OFF

ON OFF OFF ON OFF OFF OFF OFF

OFF ON OFF ON OFF OFF OFF OFF

ON ON OFF ON OFF OFF OFF OFF

OFF OFF ON ON OFF OFF OFF OFF

ON OFF ON ON OFF OFF OFF OFF

ON OFF

OFF ON ON ON OFF OFF OFF OFF

ON ON ON ON OFF OFF OFF OFF

OFF OFF OFF OFF ON OFF OFF OFF

Etc.

126

OFF ON ON ON ON ON ON OFF

Table 1 - Address Switch Settings

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

MORLEY ZX10Se Installation Manual Page 9