MORLEY ZX10Se Installation Manual download pdf (Page 6)

ZX Fire Alarm Control Panels MORLEY-IAS

Commissioning Manual Document No. 996-175-000-3, Revision 3 Page 1

1 Introduction

1.1 Notice

 The material and instructions covered in this manual have been carefully checked for accuracy and

are presumed to be correct. However, the manufacturer assumes no responsibility for inaccuracies

and reserves the right to modify and revise this document without notice.

 These instructions cover the programming of the Fire Alarm Control

Panel. Refer to the Installation Manual (P/N 996-174-000-X) for

details of how to install the system and refer to the User Manual

(P/N 996-182-000-X) for information on operation and use of the

panel.

 If System Sensor / Morley-IAS / Honeywell Multi-sensor or Laser devices are incorporated into your

installation, ensure that you have the current Universal Loop Driver card appropriate to the protocol

you are using. If you have any doubt as to the correct version to fit, please contact Technical Support.

 The ZX1Se, ZX2Se, ZX5Se and ZX10Se Fire Alarm Control Panels are 1, 1-2, 1-5 and 1-10 loop panels

for use with analogue addressable devices from the following detector manufacturers’ ranges:

Apollo

S90

Hochiki

Morley-IAS

Nittan

System Sensor

1.2 Warnings and Cautions

These instructions contain procedures to follow in order to avoid injury and damage to

equipment. It is assumed that the user of this manual has been suitably trained and is

familiar with the relevant regulations.

All equipment is to be operated in accordance with the appropriate standards applicable

For use with software

version 837 onwards

1 2 3 4 5 6 7 8 9 10 11 ... 73 74

No comments

MORLEY ZX10Se Installation Manual Page 6