MORLEY ZX2Se User Manual download pdf (Page 4)

MORLEY-IAS FIRE 6.21 User Manual

Page 4 of 51 Document No 996-140-000-9, Revision: 9 User Manual

1 Introduction

1.1 Notice

 The material and instructions covered in this manual have been carefully checked for accuracy and

are presumed to be correct. However, the manufacturer assumes no responsibility for inaccuracies

and reserves the right to modify and revise this document without notice.

 These instructions cover the use and operation of the ZX Windows

Configuration Tool. Refer to the Fire Alarm Control Panel

Commissioning Manual for information on setting up the Fire Panel to

be programmed using the Configuration Tool.

1.2 Warnings and Cautions

These instructions contain procedures to follow in order to avoid injury and damage to

equipment. It is assumed that the user of this manual has been suitably trained and is

familiar with the relevant regulations.

All equipment is to be operated in accordance with the appropriate standards applicable

1.3 National Approvals

 This equipment must be installed and operated in accordance with these instructions and the

appropriate national, regional and local regulations specific to the country and location of the

installation. Consult with the appropriate Authority Having Jurisdiction (AHJ) for confirmation of the

requirements.

EN54

EN54-2 13.7

Maximum of 512

sensors / manual

call points per

panel.

 The ZXe and ZXSe range of panels have many features, which if used

inappropriately, may contravene the requirements of EN54. Where such a

possibility may arise, a suitable warning is given with brief details of the

EN54 requirement and the relevant section it pertains to. A typical EN54

non-compliance warning is illustrated.

For use with panel

software version 845

onwards

1 2 3 4 5 6 7 8 9 ... 50 51

No comments

MORLEY ZX2Se User Manual Page 4